Filter
Top Products
Page 4
These brewers require either 3-wire, grounded service rated 120/208 or 120/240 volts ac or 2-wire, grounded
service rated 200 volts ac, or 20 amp, single phase, 60 Hz. Refer to the product’s data plate above the dilution
nozzle for actual voltage of your particular brewer model.
Electrical Hook-Up
CAUTION – Improper electrical installation will damage electronic components.
1. An electrician must provide electrical service as specifi ed.
2. Remove the top lid and rotate the control thermostat knob fully counterclockwise to the “OFF” position and
reinstall the top lid.
3. Remove the rear trunk panel, feed the cord through the strain relief at the rear of the brewer and connect it
to the terminal block.
4. Using a voltmeter, check the voltage and color coding of each conductor at the power source.
5. Connect the brewer to the power source and verify the voltage at the terminal block and reinstall the rear
trunk panel.
6. If plumbing is to be hooked up later be sure the brewer is disconnected from the power source. If plumbing
has been hooked up, the brewer is ready for Initial Set-Up.
WARNING – The brewer must be electrically grounded using the green screw near the terminal block. Do not
assume a plumbing line will provide an adequate ground.
100V.A.C.
NEUTRAL
WHITE
L1 BLACK
ELECTRICAL REQUIREMENTS
CAUTION - Do not connect the brewer to the power source until specifi ed in Initial Set-Up.
200V.A.C.
10792 050405