Filter
Top Products
8
OPERATING CONTROLS
FIG 4 Refrigeration Switch
FIG 5
DISPENSER USE
Press and Hold Dispensing:
1. Place a cup on the drip tray beneath the desired dispensing nozzle.
2. Press and hold the “Product Dispense” switch until the beverage reaches the desired level, then release.
Refrigeration Switch
The refrigeration switch is located on the rear of the dispenser
near the center. This switch controls power to the water bath
pump and relay contacts for the compressor and condenser
fan motor.
P3580-1
A. Product Dispense Switch
Pressing and holding switch will initiate product flow from the respective nozzle; releasing the switch will
stop the flow.
B. Dispense Lockout Switch
This switch is located at the bottom front of the dispenser just behind the drip tray. It is used to turn ON and
OFF the Dispensing function. It is also used for some programming and fill procedures.
FIG 6
P3583 P3612
38945 050106