Filter
Top Products
10
INITIAL FILL & HEAT
1. Select Normal and Run on the Selector switches.
2. Confirm the water supply is on.
3. Connect the dispenser to the power source.
4. The Red POWER LED will illuminate and water will begin flowing into the tank. The dispenser will automatically
stop filling when the tank is full. The dispenser will not begin heating the water until after the tank is filled.
The LCR-1 will begin to cool the cabinet after a 3 min. delay.
5. The Green READY LED will illuminate when the tank temperature reaches the preset Ready temperature.
5 4
1
44806.1 081211