Filter
Top Products
Page 18
PROGRAMMING THE BREWER (cont.)
SET NEW RECIPE (cont.)
8. Using (-) and (+), set the amount of brew water, in
ounces, to be dispensed for that particular batch
size.
9. When finished, press another batch size and re-
peat step 8 for that size. Continue setting all batch
sizes.
10. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCH
SIZES DONE?
11. If the three batch sizes are not correct, press and
release NO to return to the BREW OUNCES setup
screen and repeat steps 8 through 10. If the three
batch sizes are correct, press YES. This will advance
to the % BYPASS function. (Refer to % BYPASS
for description).
P2416
% BYPASS XX.X
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PULSE BREW?
NO YES
12. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
13. When finished, press another batch size and repeat
step 12 for each batch to be set.
14. When finished setting each batch size, press DONE.
The display should read 3 BATCHES DONE?
15. If the three batch sizes are not correct, press and
release NO to return to the % BYPASS setup screen
and repeat steps 12 through 15. If they are correct,
press YES. This will advance to SET PULSE BREW.
(Refer to SET PULSE BREW for description).
16. To SET PULSE BREW, if setting pulse brew using
EASY PULSE (brewing into a funnel) press YES
and proceed with the setup instructions for SET-
TING PULSE BREW - EASY PULSE.
17. If setting pulse brew by ENTER TIMES (entering
known times) press NO. The display should read
ENTER TIMES. Press and release YES and proceed
29877-3 062005
(COFFEE NAME)
SETUP COMPLETE
DRIP TIME X:XX
(-) DONE (+)
3 BATCHES DONE?
NO YES
P2418
with the setup instructions for SETTING PULSE
BREW - ENTER TIMES. SET DRIP TIME. (Refer
to SET DRIP TIME for description).
18. The display should now read DRIP TIME, along
with either the word OFF, or a time will be showing.
A batch light should also be blinking.
19. Using (-) and (+), set the amount of time from
when the brew spray ends to when the funnel is
emptied of hot liquid for that batch size.
NOTE: Set to OFF to prevent funnel locks from engaging
(to disable this function), for a particular batch size.
To set to OFF, continue to press and release (-) until
OFF appears on the screen.
20. When finished, press another batch size and repeat
step 19 until all three sizes are set.
21. When finished setting all batch sizes press DONE.
The display should read 3 BATCHES DONE?.
22. If the three batch sizes are not correct, press NO to
return to the DRIP TIME setup screen and repeat
steps 19 through 21.
23. If the three batch sizes are correct, press YES.
The screen should show the name of the coffee
being programmed (modified) along with SETUP
COMPLETE.
24. After a 5 second delay, the display will advance to
the next coffee name in the brewer's memory. If
no other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and return to
the REVIEW RECIPES screen.