Filter
Top Products
Page 21
REVIEW RECIPES/MODIFY RECIPES/SET UP NO
NAME COFFEE:
This function has three parts. It allows the operator
to view the brew settings for the various coffee names
programmed into the brewer.
It also allows the operator to modify (change) any
of the BREW VOLUMES, BYPASS PERCENTAGES,
PULSE BREW TIMES, and DRIP-OUT TIMES for a
particular coffee name programmed into the brewer.
Finally, this function is used to set up the two
NO NAME coffee BREW VOLUMES, BYPASS PER-
CENTAGES, PULSE BREW TIMES, and DRIP-OUT
TIMES.
Procedure for reviewing recipes:
1. Press and hold upper right hidden switch (®) until
the display reads UNITS. Release the switch, then
press and release switch until the display reads
REVIEW RECIPES.
REVIEW RECIPES?
NO YES
<RECIPE NAME>
MODIFYSHOWNEXT
THAT WAS THE
LAST RECIPE
NO-NAME LEFT
MODIFYSHOWNEXT
EXIT TO
NEXT FUNCTION
SCREEN
SCROLLS THROUGH ALL
BREW SETTINGS FOR
NO-NAME LEFT
COFFEE NAME
SCROLLS THROUGH ALL
BREW SETTINGS FOR ANY
OTHER COFFEE NAMES
STORED IN BREWER'S MEMORY
SCROLLS THROUGH ALL
BREW SETTINGS FOR ALL
COFFEE NAMES IN MEMORY
WHEN IT REACHES LAST
RECIPE IT WILL ADVANCE TO:
P2360
2. Press YES to proceed. The display should now
read NO-NAME LEFT, along with MODIFY, SHOW
and NEXT.
3. Press and release SHOW. The screen will scroll
through all the brew settings for that particular
coffee name. When finished, the display will return
to the coffee name just viewed.
4. To see settings again, press SHOW. To advance to
the next coffee name, press NEXT.
5. To exit, press NEXT until the display reads THAT
WAS THE LAST RECIPE.
6. After 5 seconds, the display will return to the RE-
VIEW RECIPES screen. Press and release NO to
advance to the next function screen, or press and
release either ON/OFF switch located on the front
switch panel to exit the programming mode and
return to the MAIN SCREEN.
PROGRAMMING THE BREWER (cont.)
29877-3 062005