Bunn TU3 Ice Tea Maker User Manual


 
Page 15
SERVICE
This section provides procedures for testing and
replacing various major components used in this
brewer should service become necessary. Refer to
Troubleshooting
for assistance in determining the
cause of any problem.
WARNING - Inspection, testing, and repair of electri-
cal equipment should be performed only by qualified
service personnel. The brewer should be disconnected
from the power source when servicing, except when
electrical tests are required and the test procedure spe-
cifically states to plug in the brewer.
COMPONENT ACCESS
WARNING - Disconnect the brewer from the power
source before the removal of any panel or the replace-
ment of any component.
All components are accessible by the removal of
the top cover and rear inspection panel.
The top cover is attached with four #6-32 screws.
Removal of the top cover will allow access to ON/OFF
switch, start switch, brew timer, dilution timer, control
thermostat, limit thermostat and tank heater,
The rear inspection panel is attached with six #8-
32 screws. Removal of the rear panel will allow access
to the brew solenoid valve, dilution solenoid valve and
the sweetener solenoid valve (optional), .195 GPM
flow control and check valve.
Contents
Brew Solenoid Valve ........................................... 16
Brew Timer (Early Models) ................................. 17
Digital Brew Timer (Late Models) ....................... 18
Control Thermostat............................................. 20
Dilution Solenoid Valve ....................................... 21
Dilution Timer ..................................................... 22
Limit Thermostat ................................................ 23
ON/OFF Switch.................................................... 24
Start Switch ........................................................ 26
Sweetener Solenoid Valve (Optional) .................. 27
Tank Heater ......................................................... 28
Wiring Diagrams................................................. 29
HOT
LIQUID
!
CAUTION
FIG. 1 COMPONENT ACCESS
P1187
10225 031804