Filter
Top Products
10
Pull Unicouple and its hoses completely out from storage compartment located at rear of dishwasher
and attach it to the faucet adapter.
Turn water fully on before starting the dishwasher.
3
1
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieveswaterpressureand protects you, andthe
room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
3
2
1
Remove the power cord plug from the wall receptacle.
Disconnect Unicouple from faucet adapter.
2
1
If faucet has not threads: attach the faucet adapter to faucet, then tightenevery screw
of the adapter. To prevent leaking your should tighten the adapter.
2
Attach the Unicouple connector to the faucet adapter by depressing the collaratthetopoftheconnector.
When Unicouple is all the way up onto the adapter, release the collar. It willthensnapIntopositionto
lock the Unicouple in place. The Unicouple s small hose carries water from the faucet to the dishwasher.
Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain
opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher
drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
'
Connectorof ModelⅠ
A hose that attaches toa sink spraycan burstif it is installed onthe samewaterlineas thedishwasher. If yoursink has one, itis
recommendedthet the hose bedisconnectedand the hole plugged.
Fusedelectrical supply isrequired-copper wireonly.Time delay fuseor circuit breaker recommended and provide separate
circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
Make sure that the plug on the appliance remains accessible after installation.
After making sure that thevoltageand thefrequency values for the current in the home
correspondto those on the rating plate andthatthe electricalsystem issized for the
maximum voltage on therating plate, insert theplug intoan electrical socket which is
earthedproperly. If the electricalsocketto which theappliance mustbe connected is not
appropriate for the ,replace the socket ,rather than
using aadaptors or thelike as theycould causeoverheating and burns.
plug (installed bya qualified electrician)
Theappliance mustbe connected to the water mainsusingnewhose-sets.
The old hose-sets should notbe reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below theminimum
consultour Service Department foradvice.