Filter
Top Products
11
If the sink is 34 or higher from the floor, the excesswater in Unicouple hoses
cannot be drained directly into the sink. It will be necessary to drain excess
water from hoses into a bowl or suitable container that is heldoutside and lower
than the sink.
Connect the cold water supplyhose to athreaded3/4(inch)connectorandmake surethat it is
fastened tightly in place.
If thewater pipes are new or have not been used for an extended period of time,letthe water
runtomakesurethatthewaterisclearandfreeofimpurities.Ifthisprecaution is not taken,
thereis a risk that thewater inlet can get blocked and damage the appliance.
The water supplyto theappliance can alsobe connected to the house hot waterline
(centralized system, heatingsystem),as long as it doesnot exceed atemperature of60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and thewash
efficiencyslightly reduced.
Theconnection must be madetothe hot water linefollowing the same procedures asthose
for the connection to the cold water line.
DIMENSIONS(mm)
Connector of ModelⅡ
Insert the drain hoseintoa drain pipewitha minimum diameter of4 cm, or let itrunintothesink,makingsuretoavoidbending
or crimping it.Use thespecial plastic support that comes with the appliance. The free end of the hosemust be at a height
between 40 and100cm andmust not beimmersed in water.
Oncethe applianceis positioned,adjust the feet (screwingthem in or out) to adjust the
height ofthe dishwasher, making it level.In any case ,the applianceshould notbeinclined
more than 2 .
Position the appliance in the desired location. Theback should rest against the wallbehind it, andthesides, along the adjacent
cabinets or wall. Thedishwasher isequippedwithwater supplyanddrainhoses that canbe positioned tothe right or the leftto
facilitate properinstallation.
450
580
850
1135