Filter
Top Products
Please note: If your water has a high calcium content (level 5 or 6)
and you use the Clearyl Filter Cartridge we recommend to decalcify
the Z5 once or twice a year (chapter 26.1).
24a. CHANGING THE WATER HARDNESS MONITOR
COFFEE READY
• Push the Rotary Dial until you hear a beep.
FILTER
• Turn the Rotary Dial until the display shows
HARDNESS 10º DH
• Push the Rotary Dial to enter the program.
• Turn the Rotary Dial until desired hardness level is displayed.
• Push the Rotary Dial to confirm the setting.
• Turn the Rotary Dial until the display shows
EXIT.
• Push the Rotary Dial.
COFFEE READY
The Z5 will automatically remind you when it is time to decalcify
(chapter 29).
25. CHANGING PRE-SET CUP SIZES
Each beverage button has been set to certain values (pre-sets).
See chapter 5. You can change all pre-set values and enter ones.
25.1 1-AND 2-CUP BUTTONS; SPECIAL CUP BUTTON
This procedure is the same for all five coffee buttons (Fig. 3).
COFFEE READY
EXAMPLE: Changing the 1-cup Coffee Button. (Fig.3).
• Place a cup underneath the coffee spouts.
• Push and hold the 1-cup Coffee Button until the display
shows
ENOUGH? PRESS BUTTON.
• When the coffee volume in your cup is at the new desired
level, push the 1-cup Coffee Button again. The display shows
CONFIRMED ✔
COFFEE READY
From now on, this will be the amount of coffee the Z5 will produce
when you push this button.
Please note: the 1-cup and 2-cup buttons are independent of
each other. This means if you pre-set the 1-cup coffee button to
4 oz. the 2-cup button does not automatically produce 8 oz. You
can pre-set the 2-cup button completely independent.
Please note: when changing the volume for the special cup
button, place a cup under the auto cappuccino system.
25.2 CAPPUCCINO BUTTON
You can change the pre-set volumes for milk and coffee. This
allows you to adjust the volume exactly to your cup size.
Place a cup underneath the auto cappuccino system.
COFFEE READY
• Push and hold the Cappuccino Button until the display reads
ENOUGH MILK PRESS BUTTON.
• Once you have enough frothed milk in your cup, push the
Cappuccino Button again. Now the Z5 starts brewing the coffee
and the display shows
ENOUGH? PRESS BUTTON.
• Once enough coffee has been added to your cappuccino,
press the Cappuccino Button again. The display shows
CONFIRMED ✔
COFFEE READY
Please note: You can also change the pre-set parameters for
the cappuccino button in programming (chapter 26.4)
22.