Filter
Top Products
Important: Once the cleaning program has started do not
interrupt the procedure.
The MESSAGE light and the red CLEANING light are illuminated.
Important: Keep the Access door open during the cleaning
process to observe the various light indicators.
1. Push and hold the CLEANING button until its light blinks.
Make sure the water tank is at least half full.
2. Now the EMPTY TRAY light blinks, too.
3. Remove and empty the drawer and used coffee container
and replace complete assembly (Fig. 19).
4. Important: Even if the drawer and the used coffee container
are empty, you still need to remove them for approx. 20
seconds and then replace them.
5. The CLEANING light is on (stops blinking).
6. Place a large cup (at least 12 oz.) under the coffee spouts.
7. Push the CLEANING button (Fig. 3a). The C5 disperses
water through the coffee spouts. Then the PRE-GROUND
COFFEE symbol blinks (Fig. 3).
8. Open the ground coffee lid and drop in one white cleaning
tablet (Fig. 20) and close lid.
9. Push the CLEANING button. The cleaning program will
dispense foamy water in intervals through the coffee spouts.
This will take a few minutes.The CLEANING light blinks.
10. After a few minutes the EMPTY TRAY light blinks.
11. Lift and remove the drawer. Empty the used coffee container
and drawer and replace.
12. The RINSE symbol blinks indicating that the machine is
heating up.
The C5 automatically remind you when it’s time to run this cleaning
cycle again. The machine is now ready to brew coffee again.
17a. MANUAL TABLET CLEANING
Attention: You can run a tablet cleaning cycle at anytime even if
the machine does not prompt you.
The machine is ready to brew coffee.
• Push and hold the CLEANING button until the MESSAGE light,
the CLEANING light and the EMPTY TRAY light blink.
• Continue with step 3 above.
18. DECALCIFYING
The machine has an integrated decalcifying program. This program
takes 45 minutes. When the MESSAGE light and DECALCIFYING
light are both on, it is time to decalcify the machine.
You can still make coffee. It is recommended to decalcify the
machine within the next 4 to 5 days.
You can buy decalcifying tablets from your local Jura dealer or
with the enclosed mail order form (see chapter 20). One package
contains three sets of three tablets, good for three decalcifying
procedures.
Please note: If you use the Clearyl Blue water cartridge and the
decalcifying message shows up, your cartridge function was
not activated. Follow the instructions in chapter 15a to activate
the Clearyl Blue cartridge. If the cartridge is in use for several
weeks install a new cartridge.
Important: The decalcifying program must not be interrupted.
NOTE: Only use our special, square decalcifying tablets, see
chapter 20.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
CAUTION: Immediately remove any splashes of the decalcifying
solution from sensitive surfaces, such as natural stone or wood.
21.