Filter
Top Products
16
Models 750, 751, 754, 774, 794Operating Procedures
Insert the drive shaft into the freezing cylinder, hex end
first, and into the rear shell bearing until the seal fits
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. Be sure the drive
shaft fits into the drive coupling without binding.
Figure 4
Step 2
Take one of the scraper blades and slip it under the
hook at the front of t he beater. Wrap the blade around
the beater following the helix and pushing the blade
down onto the helix as you wrap. At the back end of the
beater, slip the blade under the hook. Repeat this
step for the second scraper blade.
Figure 5
Holding the beater s ecurely, slide the beater one third
of the way into the f reezing cylinder. Looking into the
freezing cylinder, alignthe hole at the rear of the beater
with the flats on the end of the drive s haft.
Figure 6
Slide the beater the remainder of the way into the
freezing cylinder and over the end of the drive shaft.
The beater should fit snugly, but not so tightly that the
beater cannot be turned slightly to engage the drive
shaft. If the beater slides in too eas ily with little or no
resistance, there will not be enough force against the
beater to hold the blades in place. If this is the case,
contact your authorized Taylor service technician.
Repeat steps 1 and 2 for the other side of t he freezer
on Models 754, 774, and 794.
Step 3
Assemble the freezer door. Place the large rubber
gasket(s) into the groove(s) on the back side of the
freezer door.
Slide the whit e p lastic front bearing(s) over the baf fle
rod(s) onto the bear ing hub(s) making certain that the
flanged endof the bearingis resting against thefreezer
door.
Note: Do not lubricate the gasket(s) or the front
bearing(s).
Figure 7