Filter
Top Products
Use
Humidity Control (all models except FWC151)
The wine coolers are equipped with a humidity control
system to maintain optimal humidity within the wine cooler.
Fill the humidity reservoir approximately 3/4 full with water.
Place the reservoir on the runners on the top shelf as shown
in fig. 5. Ensure it is located correctly to prevent water
spillage.
Check the water level regularly and refill if required.
Temperature display
The temperature display will show the current internal temperature.
The display flashes:
• When a different temperature is being set
• If the internal temperature is +/- 5˚ away from the set temperature. This serves as a warning to prevent
damage to the contents of the appliance should the temperature be too high.
Dynamic Cooling and Silent modes
The appliance has two different running modes.
• Silent mode
Once the required temperature is reached, the appliance will run without the fan.
• Dynamic cooling mode
The fan cycles on and off to circulate the air even after the required temperature is reached. This ensures consistent humidity
and temperature distribution in the wine cooler, creating perfect conditions for long term storage. Dynamic cooling is the
factory preset mode.
To change to silent mode, touch and hold the up key for approximately five seconds. The wine cooler will beep three times to
confirm silent mode is on.
To change to dynamic cooling mode, touch and hold the down key for approximately five seconds. The wine cooler will beep
five times to confirm dynamic cooling is on.
fig. 5
6