Filter
Top Products
20
Fastening the Cooktop
Each cooktop is supplied with a set of tabs and screws to fasten it on units with a working surface from 2
to 4 cm deep.
The kit includes 4 tabs A and 4 self-threading screws B (fig. 11).
– Cut the unit.
– Turn the hob upside down and rest the glass side on a cloth.
– Spread the seal C around the edge of the hob (fig. 12).
– Put tabs A into the mountings; only tighten screws B a few turns.
Make sure that the tabs are mounted correctly as shown in the figure 11.
– Put the cooktop into the hole cut into the unit and position it correctly.
– Put tabs A into place, tooth D of the tabs should go into the hole.
– Tighten screws B until the cooktop is completely secured.
– Using a sharp tool cut off the part of gasket C which protrudes from the cooktop. Take care not to
damage the workbench.
A
A
Fig. 12
Adhesive side
C
C
20 mm min.
40 mm max.
A
D
B
C
Fig. 11