Filter
Top Products
6
English
XA311
5. OPERATION
CAUTION
Note:
•
Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold).
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
1) Press the POWER button 5.
*
To turn the power off, press the POWER button
for at least 1 second.
2) Press the FUNC button 5 to select another
operation mode. The mode switches as fol-
lows each time the FUNC button is pressed:
Radio ➜ Tape ➜ CD changer ➜ Radio
*
If a component is not connected, that operation
mode cannot be selected.
*
“CASS” appears when no tape is loaded in the
source unit, and “DISC” appears when no disc is
loaded in the CD changer.
Adjusting the volume
Turning the Rotary knob 3 clockwise increases
the volume; turning it counterclockwise decreas-
es the volume.
*
The volume level is from 0 (minimum) to 33 (maxi-
mum).
Setting the Z-enhancer
This unit comes with 3 types of sound tone
effects stored in memory. Select the one you
prefer.
*
The factory default setting is “OFF”.
Each time you press Z-EHCR button
7, the tone
effect changes in the following order:
“Z-ENHANCER 1” ➜ “Z-ENHANCER 2” ➜ “Z-
ENHANCER 3” ➜ “OFF” ➜ “Z-ENHANCER
1”...
• Z-ENHANCER 1 : bass emphasized
• Z-ENHANCER 2 : treble emphasized
• Z-ENHANCER 3 : bass and treble empha-
sized
• OFF : no sound effect
Adjusting the tone
Press A-M button 4 and select the item to
adjust. Each time you press A-M button 4, the
item changes in the following order:
“BASS” ➜ “TREB” ➜ “BAL” ➜ “FAD” ➜
Function mode...
Adjusting the bass
1. Press A-M button 4 and select “BASS”.
2. Turning the Rotary knob 3 clockwise
emphasizes the bass; turning it counter-
clockwise attenuates the bass.
*
The factory default setting is “0”. (Adjustment
range: –6 to +6)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
Adjusting the treble
1. Press A-M button 4 and select “TREB”.
2. Turning the Rotary knob 3 clockwise
emphasizes the treble; turning it counter-
clockwise attenuates the treble.
*
The factory default setting is “0”. (Adjustment
range: –6 to +6)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
Adjusting the balance
1. Press A-M button 4 and select “BAL”.
2. Turning the Rotary knob 3 clockwise
emphasizes the sound from the right speak-
er; turning it counterclockwise emphasizes
the sound from the left speaker.
*
The factory default setting is “0”. (Adjustment
range: L9 to R9)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
Basic Operation