Filter
Top Products
■ A good flame should be blue with minimal
yellow tip. Some yellow tips on flames are
acceptable as long as no carbon or soot
deposits appear (Fig. 22).
GOOD
Yellow
Blue
Holes in Burner
Blue
Yellow
BAD
NOTE: If the burner flame is accidentally
extinguished, turn off the control knob
and wait 5 minutes before relighting
the appliance.
12.
Adjust flame with the control knob (Fig. 19).
MMaattcchh LLiigghhttiinngg::
CAUTION
Use a LONG wooden match or a butane
lighter with an extension. Make sure all
burner controls are off except for the
burner being lighted. If a long-reach
match or lighter is not accessible, use the
match extension. The match extension is
located inside the doors. Insert a match in
the holder end of the extension, strike and
place the burning match near the
BURNER being operated. Removing the
Fryer Grease Pan will make it easier to
access the Fryer Burner. Be sure to
replace the Fryer Grease Pan as soon as
the burner stays lit.
1. Open the lid.
2. Make sure all valves are OFF.
3. Turn on the cylinder valve.
4. Strike and place the burning match
near the burner gas port holes, from
below the fryer.
5. Push in and turn on the Fryer Control Knob
counterclockwise to HIGH (Fig. 20).
6. Continue to depress and hold the Fryer
Control Knob.
7. After burner ignition, continue to hold Fryer
Control Knob in for 15-30 seconds.
English-9
Turn off the control knob (Fig. 23).
To Turn Off
Fig. 19
Fig. 23
Fig. 21
Fryer Burner
Lighting
(cont.)
8. Adjust flame with the control knob (Fig. 21).
Fig. 20
Fig. 22