Filter
Top Products
5. Place the basket in the fryer (Fig. 13). This
illustration shows the basket in the upper
position for draining the food after frying.
English-7
Leak Testing
How to Check for Leaks
1.
Make a soapy solution of equal parts mild
liquid dishwashing detergent and water.
2.
Turn off all burner control knobs.
3.
Turn on the fuel supply by turning the
cylinder valve knob counterclockwise (right
to left) one rotation.
4. Apply a soap solution to the connections
indicated with the arrows in Fig. 15 and 16. If
bubbles appear at these areas, a leak is
indicated.
5. Also follow the “Leak Check” section in the
manual that came with your grill.
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor fryer until connection
has been leak tested and does not leak.
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect propane cylinder and fryer propane
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak.
Never use a flame.
Fig. 15
Fig. 16
Setup (cont.)
Fig. 13
6. Figure 14 shows the basket lowered into the oil
for frying. Never close the lid during use.
Fig. 14
CAUTION
Inspect the gas supply hose before each
use. Look underneath the grill to inspect
the hose assembly below the grill. If
there are cuts, damage, excessive
abrasion or wear, replace the hose prior
to operating the appliance. During
assembly of the grill and when attaching
or replacing the L.P. gas cylinder, insure
that the gas supply hose is free of kinks
and/or damage and is at least three
inches away from hot surfaces such as
the grill housing. Use only hose
replacements specified in the parts list.