Filter
Top Products
12
7. Remove the four #15
Torx plastic collar
screws from the
fountain/escutcheon
collar.
8. Place the fountain/
escutcheon collar onto
the backer panel. Use
tape to hold in place.
9. Open the freezer door
and slide panel onto
the door.
10. The holes in the
fountain/escutcheon
collar should line up
with the mounting
holes in the door
panel. Reverse
instructions 7 to 1
(ex. Replace the
four #15 Torx plastic
collar screws from the
fountain escutcheon
collar)
insTallaTion insTRuCTions
7
8
9
10
CAUTION
WARNING – Do not exceed the panel dimensions shown in the chart on
page 4 for the grille panel. If the decorator panel is larger than specified,
it may restrict the airflow to the compressor and condenser area, which
may cause the unit to function improperly.
IMPORTANT: When attaching a raised wood panel of 1/2” or
thicker secure the raised panel to the back of the grille cover
frame. Use 4 #8 or similar screws.
Spill Tray Grille
Stainless Steel
Splashguard
Terminals
Control Panel
Adjust Door Hinges
Check to make sure the doors are properly aligned. If not, the
door hinges will have to be adjusted. Remove the two small
shipping screws from the top and bottom hinge as shown below.
Next, using a #25 torx screwdriver, loosen the torx head screws
in the top and bottom hinge. Loosen the torx head screws only
slightly, so that the door will remain in position as you adjust it.
You will now be able to move the door to the left or right. Once
the adjustments are made, tighten the torx head screws - do not
put the shipping screws back.