Filter
Top Products
8
Installation Instructions
To adjust the rear leveling legs, rotate the #2 Phillips
drive shafts, located at the toe-kick, to level the
dishwasher from front to back and left to right.
It is important to level the dishwasher from left to right and
front to back. Shimming may be required on extremely
uneven flooring materials. If shims are needed, place the
shim(s) under the adjustable legs.
IMPORTANT:
Do not reinstall the toe kick mounting plate until the
installation is inspected for leaks (see page 11).
Make sure to anchor at least one anti-tip bracket on
each side of the dishwasher.
The anchoring material must be no more than 1/4”
(6mm) from the anti-tip bracket.
4.
•
•
•
Install the Anti-Tip Brackets
CAUTION
Make sure to anchor at least one anti-tip bracket on
each side of the dishwasher.
The anchoring material must be no more than 1/4”
(6mm) from the anti-tip bracket.
•
•
The anti-tip brackets protect against possible tipping
caused by heavy bottom rack loads on the door.
There are anti-tip mounting locations provided around
the top and sides of the dishwasher front frame.
To attach the anti-tip bracket anchors:
Insert the anchoring screws through the 1/2” diameter
access holes inside the dishwashing compartment on
the ceiling and the sides, near the front. Make sure that
the anchoring screws pass through the anti-tip brackets
located on the outside of the dishwasher.
Alternate method:
Insert the anchoring screw through the 1/2” diameter
tank access hole. Make sure that the anchoring screw
passes through the anti-tip bracket located on the
outside of the dishwasher.
•
•
•
•
Leveling the Dishwasher (continued)
Front leg
adjustment
nut
Rear leg
adjustment
hex rod
Top anti-tip
bracket
Side anti-tip
bracket