Filter
Top Products
8
2. Cut and remove the foil material inside the knock-out
hole. If you fail to remove the foil, the vent will not work.
3. If the unit will vent through the bottom or side:
• Attach the supplied ATD2 transition to exhaust
location with the provided sheet metal screws.
• For bottom installations cut a hole in the cabinet
floor to allow the exhaust transition and/or the duct
to pass through the floor.
4. If the unit will exhaust air from the back, attach a
3 ¼” X 10 duct to the vent hole created by removing
the knock-out on the back of the unit.
Installation Instructions
Back of unit
Side
knock-out
Side
knock-out
Bottom knock-out
Rear knock-out with
metal cross overs
shown
Vent Knock-out Locations - Rear View
ADT2 side
installation
ADT2 bottom
installation
Attach sealing
foam
ADT2 Transition Installation
Floor
Cut hole in floor to allow
duct to pass through on
bottom venting installations
Top of vent resting
on countertop
Installation Preparation
Verify Package Contents
• Product literature
• Anchoring legs
• 2 wood screws, #14 x 2 ½ (PN 83047)
• 3 wire nuts
• ADT2 duct transition
• 2 sheet metal screws, #10 x ½ (PN 83022)
• 2 keps nuts, ¼-20 (PN 83049)
• 2 flat washers, ¼-20 (PN 83203)
• Insulation foam
Installation
WARNING
• If the electrical service (electrical outlet) does not meet
the Electrical Specifications on page 4, do not
proceed with the installation. Call a licensed electrician
and have an electrical outlet installed that meets the
specifications.
• Install the vent only in a vertical orientation. Do not
mount the vent on a slant or angle.
• Do not enlarge or modify the exhaust knock outs or
cut an exhaust hole in a location on the chassis other
than those shown. Doing so may cause an increase in
noise and decrease performance.
NOTE: The raised vent installs in the back of the cutout,
separate from the cooking appliance. Install the raised vent
before installing the cooking appliance.
Installing the Raised Vent
1. Remove the appropriate side, back or bottom exhaust
knockout, depending on the desired exhaust configura-
tion, from the raised vent chassis by cutting the metal
cross overs and removing the insert.