Filter
Top Products
14
15
Cleaning anD Care
Exterior
The outside surface is precoated metal and plastic. Clean
the outside with mild soap and water; rinse and dry with a
soft cloth. Do not use any type of household or abrasive
cleaner.
Stainless Steel Surface
(Select Models)
The exterior should be wiped often with a soft damp cloth
and polished with a soft dry cloth to maintain its beauty.
Always wipe in the direction of the grain. There are also
a variety of products designed especially for cleaning and
shining the stainless exterior of the oven. We recommend
that the cleaner be applied to a soft cloth and then carefully
used on the stainless exterior rather than sprayed directly
on to it. Follow package directions carefully
.
Front Side Of The Drawer
Wipe the window on both sides with a soft damp cloth to
remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a soft damp cloth. Avoid
the use of spray cleaners and other harsh cleaners as they
may stain, streak or dull the door surface.
Touch Control Panel
If desired, the touch pads may be deactivated before
cleaning. See the Control Lock information on page 13 of
this manual.Wipe the panel with a cloth dampened slightly
with water only. Dry with a soft cloth. Do not scrub or
use any sort of chemical cleaners. Close door and follow
directions on page 13 for turning Control Lock off. Touch
STOP/CLEAR.
Interior
Cleaning is easy because no heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces,
including drawer sealing surfaces, wipe with a soft damp
cloth. DO NOT USE ABRASIVE OR HARSH CLEANERS
OR SCOURING PADS. For heavier soil, use mild soap;
wipe clean with a soft damp cloth. Do not use any chemical
oven cleaners
.
Microwave In-A-Drawer
™
Guides
Remove the food crumbs from the Drawer guides. Wipe
with a soft dry cloth in order to keep the Microwave In-A-
Drawer
™
opening and closing smoothly.
Waveguide Cover
ATTENTION
The waveguide cover, located on the inside top
of the Microwave area, is made from mica, so it requires
special
care. Keep the waveguide cover clean to assure
good microwave performance. Carefully wipe with a soft
damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes may
overheat and cause smoke or possibly catch fire. Do not
remove the waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the Drawer. To
remove, combine 1 cup water, grated peel and juice of one
lemon and several whole cloves in a 2-cup glass measuring
cup. Boil for several minutes using 100% power. Allow to
set in the Microwave In-A-Drawer
™
until cool. Wipe interior
with a soft cloth.