Filter
Top Products
7
TURNTABLE INSTALLATION
1. Place the roller rest on the cavity bottom.
2. Make sure the turntable shaft is installed inside the hole in the (center) cavity bottom.
3. Place the turntable on top of the roller rest as shown in the diagram. Make sure the turntable
hub is properly positioned on the turntable shaft.
• Never place the turntable upside down. The turntable should never be restricted.
• Both turntable and roller rest must always be used during cooking.
• All foods and containers of food should always be placed on the turntable for cooking.
• When cooking is finished the light and fan turn off automatically, followed by an
end of cooking signal. (5 beeps)
• The turntable is designed to rotate in a clockwise or counter-clockwise direction;
this is normal.
• If turntable or roller rest cracks or breaks, contact your nearest authorized service center.
Remove all packing material and accessories. Examine the oven for any damage such as dents or
broken door. Do not install the oven if it is damaged.
NOTE: This unit is designed to operate on a 120-volt/60-Hz AC circuit.
Cabinet: Remove any protective film found on the cabinet surface.
Do not remove the light brown Mica cover that is screwed to the oven cavity
(right side wall) to protect the magnetron.
Safety interlock system: Shuts off oven power if door is opened during operation