Filter
Top Products
Page 3
Replacing the freezer door
Lower the freezer door bottom hinge hole over
the bottom hinge pin and close the door.
Slide the back of the top hinge into the slot and
lower the hinge pin into the top hinge hole of the
door.
Tighten the hinge fastener and re-connect the
harness wiring. (earth wire for refrigerator door)
Snap the hinge cover in place and tighten the
screw.
1
2
3
4
Replacing the refrigerator door
Repeat steps 1 to 4 as described above.
Installation
The appliance should be positioned in a dry, well aired place away from heat
sources such as stoves, geysers and direct sunlight. Allow an airspace at the rear of
the refrigerator for ventilation purposes.
An electrical wall plug should be nearby and easily accessible
.
Electrical Installation
This appliance uses a 220-240V/50 Hz power supply.
The appliance should be plugged into a dedicated 15A earthed wall socket. Do not
use an extension cord or multiple adaptor.
If the mains power cord is damaged, it must be replaced by a qualified electrician.
This appliance must be earthed and the manufacturer and the seller do not accept
responsibility for any damage due to incorrect electrical connection.
This appliance may not be used with a battery inverter power supply.
1
2
3
4
5
1
2