PAGE 11 OF 16
Maintenance.
Oven light
The oven light is switched on by the multifunction selector switch and switches off when
the knob is returned to 0.
To replace a faulty light bulb, proceed as follows.
• Switch off the power at the wall switch to avoid the possibility of electric shock.
• Remove the light cover by unscrewing it in an anticlockwise direction.
• Unscrew the faulty bulb and fit a new 25 watt bulb rated for 300°C.
• Refit the light cover.
Warmer drawer
• The warmer drawer has a rotary on-off switch
• An indicator light will glow when the drawer has been switched on.
• Food left for too long in the warmer drawer could dry out and spoil. As a precaution food
should always be covered, to minimise the drying effect.
• The drawer can be removed for cleaning purposes. Pull the drawer out to the bump- stop,
then lift the front slightly and continue pulling till the drawer slides free.
• Refit by lifting the rear of the drawer over the bump-stop and then sliding it back.
SIDE OF DOOR
SIDE OF DOOR
S
I
D
E
O
F
D
O
O
R
A
C
1 2 3
B
Removable oven door
The oven door may be removed to improve access to the oven for cleaning purposes.
1 Open the door fully to expose the hinges (A) on either side.
2 Flip the hinge locking levers (B) to the upright position.
3 Partially close the oven door and lift it free of the side panel retaining slots.
4 After cleaning, re-fit the oven door in reverse order making sure that the bottom hinge
notches © locate properly onto the bottom edges of the side panel retaining slots.