Filter
Top Products
Page 12
Care and cleaning
• Always disconnect the plug from the mains socket before cleaning the appliance.
• Clean the inside of the appliance whenever necessary using a solution of warm water and Bicar-
bonate of Soda. ( 1 table spoon to 2 litres of water ).
• Dry with a soft cloth.
• Do not use pot scourers or abrasive powders to clean the appliance.
• Do not use benzine, thinners or any volatile cleaners to clean any part of the refrigerator
• Spillages, especially citric and acidic juices, must be wiped up immediately as they could stain the
product.
• A mild furniture polish may be used on the exterior cabinet to add lustre and protect against finger
marks.
• Shelves, freezer drawers, crispers, door bins, dispenser spill grill, and the ice storage container
may be carefully removed for cleaning purposes. Use a mild liquid detergent and water and dry
with a soft lint free cloth.
• The dispenser spill grill is not self draining and should be removed and cleaned regularly.
• To remove the ice storage container, pull the container assembly up and out. To replace, align
the container with the side grooves and push it home. If this proves difficult, rotate the swirl
coil in the container a quarter turn and try again.
• To remove the dairy compartment flap, open it a little , hold it with both hands and slide to
the left.
• To remove the dairy tray, hold both ends and lift upwards.
• To remove a door bin, first remove the bottle retainer then hold both ends of the bin and lift
up.
• To remove the shelves, open the doors fully and slide each shelf out.
• To remove the crispers, lift slightly and pull free.
Replacing a freezer lamp
1. Remove the screw caps at the bottom of the light cover with a small flat tipped screw driver.
2. Unscrew the two screws securing the lamp cover.
3. Hold the lamp cover and pull forward to remove it.
4. Remove and replace the lamp with one of similar specifications.
5. Reassemble in reverse order.