Filter
Top Products
Page 3
• The appliance should be positioned in a dry, well aired place away from heat sources such as
stoves, geysers and direct sunlight.
• Allow an airspace of at least 100mm at the sides and rear of the refrigerator for ventilation pur-
poses.
• A dedicated cold water tap ( to supply water to the ice dispenser) and an electrical wall socket
should be nearby and accessible.
Electrical Installation
• This appliance uses a 220-240V/50 Hz power supply.
• This appliance must be plugged into a dedicated 15A earthed wall socket.
• Do not use an extension cord or multiple adaptor.
• If the power cord is damaged, it must be replaced by a qualified electrician.
• This appliance must be earthed and the manufacturer and the seller do not accept responsibility
for any damage due to incorrect electrical connection.
• This appliance may not be used with a battery inverter power supply.
Repositioning the Freezer door
Repositioning the Fridge door
Installation
Accessories supplied.
• An egg caddy,
• Filter box, & water supply kit
• Owner’s manual.
Insert the water tube into the bottom hinge pin hole.
Lower the freezer door bottom hinge hole over the bottom
hinge pin and close the door.
Slide the back of the top hinge into the slot and lower the
hinge pin into the top hinge hole of the door.
Tighten the hinge fastener and re-connect the wiring har-
ness and earth wire.
Push the water tube into the coupling.
Snap the hinge cover in place and tighten the screw.
1
2
3
4
5
To replace the refrigerator door, repeat the sequenceas described above noting that there are no water
connections and install the bottom plinth.