Delfield 6000 Refrigerator User Manual


 
Vantage 6000™ Series and Glass Door Merchandisers Reach-Ins Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.deleld.com
2
Vantage 6000™ Series and Glass Door Merchandisers Reach-Ins Service and Installation Manual
3
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.deleld.com
RECEIVING AND INSPECTING UNIT.................................. 2
MECHANICAL DATA ............................................................. 3
INSTALLATION...................................................................... 4
MAINTENANCE .................................................................... 4
OPERATION.......................................................................... 5
SHELF INSTALLATION ......................................................... 6
DEFROST TIMER ................................................................. 7
REFRIGERATOR AND FREEZER WIRING DIAGRAMS...... 8
REPLACEMENT PARTS LIST.......................................... 9-11
STANDARD LABOR GUIDELINES ..................................... 12
STANDARD WARRANTIES............................................ 13-14
AUTHORIZED PARTS DEPOTS......................... BACK PAGE
On refrigeration and freezer storage units, the serial tag is
located on the upper left rear corner of the cabinet exterior.
Always have the serial number of your unit available when
calling for parts or service. A complete list of authorized
Deleld parts depots is shown on the back cover of this
manual.
Copyright ©2003 The Deleld Company. All rights reserved. Reproduction
without written permission is prohibited. Vantage 6000™ Series and Vantage
Merchandisers™, and Deleld are registered trademarks of The Deleld
Company
Contents
Serial Number Location
Even though most equipment is shipped crated, care should
be taken during unloading so the equipment is not damaged
while being moved into the building.
1. Visually inspect the exterior of the package and skid or
container. Any damage should be noted and reported to
the delivering carrier immediately.
2. If damaged, open and inspect the contents with the
carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment
notify the carrier. Notification should be made verbally as
well as in written form.
4. Request an inspection by the shipping company of the
damaged equipment. This should be done within 10 days
from receipt of the equipment.
5. Check the lower portion of the unit to be sure legs or
casters are not bent.
6. Also open the compressor compartment housing and
visually inspect the refrigeration package. Be sure lines
are secure and base is still intact.
7. Freight carriers can supply the necessary damage forms
upon request.
8. Retain all crating material until an inspection has been
made or waived.
Uncrating the Equipment
First cut and remove the banding from around the crate.
Remove the front of the crate material, use of some tools will
be required. If the unit is on legs remove the top of the crate
as well and lift the unit off the skid. If the unit is on casters it
can be "rolled" off the skid.
Receiving and Inspecting the Equipment