Filter
Top Products
1. Position cabinet floor on a flat, level surface with the slotted
end facing up.
• Ensure the entryway is facing forward
(gray plastic transition piece)
• Insert one alignment block into the channel in between each
of the locking cams.
2. Raise the first panel (with the evaporator, fans and air
channel) onto the mounting floor with the fans facing inside.
• Place bottom of the panel into the alignment channel on the
mounting floor for proper placement, using the alignment
block to align panel.
NOTE: Do not break alignment block when placing panels in
place.
The first panel will be the left side of the unit if you are facing
the door.
NOTE: Ensure all cam locks are in the open position before
placing any panels.
Make sure the skirt on the vertical panels covers
the outside of the mounting floor.
Lock bottom locking cams on
the outside of the first panel.
Insert T-handle wrench and
twist clockwise until a positive
stop is achieved.
The panel will now stand on
its own.
NOTE: Do not lean or push on unsupported
panels.
3. Attach the back panel to the
mounting floor in the same manner
as the first panel. The back panel
will wrap around both sides.
NOTE: Ensure all cam locks are in
the open position before placing
any panels.
NOTE: Do not break alignment block when placing panels in
place.
Lock the side locking cams on the outside of the first panel
and the left side and bottom locking cams on the inside of the
back panel. Insert T-handle wrench and twist clockwise until a
positive stop is achieved.
• Attach deflector shields either side of the
first panel as shown. The deflector shields
will cover the corners on the first panel and
are attached with provided screws.
T40 Installation and Assembly