Filter
Top Products
LIGHTING GAS BURNERS
■ Check that the electricity is switched on to allow spark ignition.
■ Make sure that all controls are turned to zero.
■ The gas flow to the burner is controlled by a tap incorporating a safety cut-off
valve. If the burner flame should go out for some reason, the safety
valve will automatically stop the gas flow. The switch of the electric ignition is
incorporated in the knobs.
■ You control the flow by turning the knob indicator to line up with the following
symbols:
– Symbol : tap closed
(burner off)
– Symbol : High (maximum)
– Symbol : Low (minimum)
To light one of the gas burners, follow the procedure LIGHTING GAS BURNERS on
page 16.
To reduce the gas flow to minimum, rotate the knob further anti-clockwise to point
the indicator towards the small flame symbol.
The maximum aperture position permits rapid boiling of liquids, whereas the minimum
aperture position allows slower warming of food or maintaining boiling conditions
of liquids.
Other intermediate operating adjustments can be achieved by positioning the
indicator between the maximum and minimum aperture positions, and never between
the maximum aperture and closed positions.
N.B. When the cooker top is not being used, set the gas knobs to their closed positions
and also close the cock valve on the gas bottle or the main gas supply line.
15
Figure 17
Figure 16