Filter
Top Products
15
Programming the quantity of coee and milk
in the cup for the CAPPUCCINO, FLAT WHITE and
LATTE buttons
The appliance is set by default to automatically deliver standard
quantities. To change these quantities, proceed as follows:
1. Place a cup under the coee spouts and milk spout.
2. Select the desired froth dial position for the drink type to
be programmed.
3. Press and hold one of the function buttons until the name
of the hot drink and the message “PROGRAM MILK” is
displayed.
4. Release the button. The appliance starts delivering milk.
5. Once the required quantity of milk has been delivered into
the cup, press the button again.
6. The appliance stops delivering milk and, if included in the
drink, after a few seconds the coee is delivered into the
cup: the name of the hot drink and “PROGRAM COFFEE” is
displayed.
7. Once the required quantity of coee has been delivered
into the cup, press the button again. Coee delivery stops.
The machine is now reprogrammed with the new milk and cof-
fee quantities.
Programming the quantity of coee and milk in
the cup for the MILK MENU button drinks
The appliance is set by default to automatically deliver standard
quantities.
To change these quantities, proceed as follows:
1. Press the MILK MENU button.
2. Press < or > until the required drink is displayed (MILK,
CAFFELATTE, ESPRESSO MACCHIATO or MY MILK).
3. Hold the OK button until the name of the drink and “PRO-
GRAM MILK” are displayed.
4. Release the button. The appliance starts delivering milk.
5. Once the required quantity of milk has been delivered into
the cup, press the OK button.
6. The appliance stops delivering milk and, if included in the
drink, after a few seconds the coee is delivered into the
cup: the name of the hot drink and “PROGRAM COFFEE” is
displayed.
7. Once the required quantity of coee has been delivered
into the cup, press the OK button again. Coee delivery
stops.
The machine is now reprogrammed with the new milk and cof-
fee quantities.
DELIVERING HOT WATER AND STEAM
Important! Danger of burns.
Never leave the machine unsupervised while delivering hot
water or steam.
The spout becomes hot. Hold by the handle only.
Please note!
If “Energy saving” mode is active, you may have to wait a few
seconds before the hot water or steam is delivered.
Delivering hot water
1. Make sure the hot water spout is attached correctly (g. 7).
2. Place a container under the spout (as close as possible to
avoid splashes).
3. Press the button (g. 3). “HOT WATER” is displayed,
together with a progress bar which lls gradually as pre-
paration proceeds.
4. The machine delivers 250 ml of hot water, then delivery
stops automatically. To interrupt delivery of hot water ma-
nually, press the button again.
Changing the quantity of water delivered
automatically
The machine is set by default to automatically deliver 250 ml
of hot water.
To modify these quantities, proceed as follows:
1. Position a container under the spout.
2. Press and hold the button until “Hot water Program
quantity” is displayed, then release the button.
3. When the hot water in the cup reaches the required level,
press the button again.
The machine is now reprogrammed with the new quantity.
Delivering steam
1. Make sure the hot water spout is attached correctly (g. 7).
2. Fill a container with the liquid to be heated/frothed and
immerse the spout/traditional frother (D5) in the liquid.
3. Press the button: after a few seconds, steam comes
out of the traditional frother and heats the liquid; “STEAM”
is displayed.
4. When the required temperature is obtained, interrupt
steam delivery by pressing the button. (You should not
discharge steam for more than 3 minutes at a time).
Important!
Always stop steam delivery before extracting the container con-
taining the liquid to avoid burns from splashes.