Filter
Top Products
16
Check that the two red buttons have snapped out, otherwise the door cannot be closed.
CORRECT
INCORRECT
The two red buttons have
snapped out
CORRECTLY
The two red buttons have not
snapped out
NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snap-
ped out, the service door cannot be closed.
NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it force-
fully from the top and bottom simultaneously, as shown in figure 28.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the outlet then plug in again.
Wait for all the lights to go off, then open the door and replace the infuser.
•replace the drip tray, complete with the grounds container;
• close the service door.
12 CHANGING AND SETTING THE MENU PARAMETERS
The following menu parameters and functions can be changed by the user:
• Clock
• Auto-start time
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
•Water hardness
• Factory default values
12.1 Setting the clock
To set the clock, proceed as follows:
•Press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays
CLOCK 00:00
•Press the button to set the clock. (If you hold the button down, the time is changed
rapidly).
•Press the button to confirm the value;
•Press the button to exit programming mode or to change other parameters.
12.2 Setting auto-start time
This programs the time the appliance will come on automatically.
• Make sure the clock on the appliance is set as described above.
•Press the button then press the button repeatedly until the appliance displays:
START TIME 00:00