Filter
Top Products
11
Setting up the appliance
Information :
• Coffee has been used to factory test the
appliance and it is therefore completely
normal for there to be traces of coffee in the
mill.
The machine is, however, guaranteed to be
new.
• You should customize water hardness as
soon as possible following the instructions
in the section “Setting water hardness” on
page 20.
1. Plug the appliance into the power outlet and
(in models provided with main switch) place
the main switch on the back of the appliance
intheIposition(g.1).
You must rst select the language (the
languages scroll through at intervals of about
two seconds):
2. When English appears, press the OK icon for
3 seconds(g. 2). Oncethe language has
been saved, the message “English installed”
is displayed.
Follow the instructions indicated by the
appliance:
3. “FILLTANK!”:removethewatertank,llto
the MAX line with fresh water then replace in
theappliance(g.3).
4. “INSERT WATER SPOUT AND PRESS OK”:
Check that the hot water spout is inserted on
the nozzle and place a container underneath
(g.4).
Press the OKicon(g.2).“PLEASEWAIT...”is
displayed and the appliance begins to deliver
hot water.
Theapplianceendstherststartupprocedure,
then the message “Turning off, please wait...” is
displayed and the appliance goes off.
The coffee maker is now ready for normal use.
Information: When using the appliance
forthersttime,youneedtomake4-5cupsof
coffee and 4-5 cappuccinos before the appliance
starts to give satisfactory results.
TURNING THE APPLIANCE ON
Information: In models provided with main
switch, before turning the appliance on, make
sure the main switch on the back of the appliance
isintheIposition(g.1).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which
cannot be interrupted.
The appliance is ready for use only after
completion of this cycle.
Danger of burns! During rinsing, a little
hot water comes out of the coffee spouts and is
collected in the drip tray underneath.
Avoid contact with splashes of water.
• Toturntheapplianceon,pressthebuttonon
the left side of the machine (g.5):the
message “Heating up... please wait” is dis
When heating is complete, the message changes
to: “Rinsing”. As well as heating the boiler, this
also heats the internal circuits by circulating hot
water.
The appliance is at temperature when the
message “STANDARD COFFEE standard taste”
is displayed.
TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be
interrupted.
Danger of burns! During rinsing, a little hot
water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the button
(g.5).Theapplianceperformstherinsecycle
then goes off.
Information: In models provided with
main switch, if the appliance is not used for an
extended period, place the main switch on the
back of the appliance in the 0position(g.6).