Delta SIG110LED Ventilation Hood User Manual


  Open as PDF
of 4
 
Page 3.
MODEL SIG110LED
2-1. Insert the duct into the duct connector and tape all ductwork
connections to make them secure and airtight. (Fig. F)
2-2. Install the duct with a gradient of 1°~2° to the outside.
3. Connect wiring
3-1. Follow all local electrical and safety codes.
3-2. NEVER place a switch where it can be reached from a tub or
shower.
3-3. Connect wires as shown in the wiring diagrams below.
BLACK
ON/OFF SWITCH
(purchase separately)
SWITCH BOX
120 VAC
LINE IN
WHITE
GROUND
(bare)
POWER
SWITCH
WIRING
PLATE
LIGHT
SWITCH
NIGHT-
LIGHT
SWITCH
YELLOW
RED
3-4. Using quick connector, connect house power wires to
ventilating fan wires.
3-5. Using wire nut (not provided), connect house ground wire to
fan ground wire.
3-6. 14 AWG (2.1 mm
2
) is the smallest conductor that shall be used
for branch-circuit wiring.
4. Grille attachment
4-1. Insert the LED light connector into the main body. (Fig. G)
4-2. With the power on, check for abnormal vibrations or sounds.
4-3. Insert the mounting springs into the slots and mount the grille
to the body. (Fig. H)
2. Duct connection
Ceiling
Body
Tape
Duct
Outside
Gradient
1°~2°
Inside
Duct connector
Fig. F
OFF
ON
L
N
POWER SWITCH
JUNCTION BOX
SWITCH BOX
WHITE
BLACK
GREEN
GRD
OFF
ON
L
N
NIGHT-LIGHT SWITCH
WHITE
YELLOW
OFF
ON
L
N
LIGHT SWITCH
WHITE
RED
QUICK CONNECTOR INSTRUCTIONS
To be sold only with installation instructions.
WARNING: Wiring must comply with all applicable electrical codes. Turn
OFF power before removing or installing connectors.
WARNING: COPPER TO COPPER ONLY. Do not use Aluminum wire.
CAUTION: Accessory part (quick connector) should meet installation
instructions.
NOTE: The connector is reusable on solid wires of the same wire gage or
smaller. Do not reuse the connector on stranded wires.
NOTE: Important wire information. Maximum temperature rating 105
O
C
(221
O
F). 600 volts maximun for building wire and 1000 volts maximum in
signs and lighting fixtures. The acceptable wire range includes:
Solid: 12-18 AWG
Strip wire 3/8"-1/2"
Grip the wire firmly and push the stripped end of the wire into the open
port of the connector. Use only one conductor per port.
Verify the stripped end of the wires is fully inserted to the back of the
connector.
House
wire
Product
wire
Quick
connector
Celling
Grille
LED light
connector
Fig. G
Spring
Slots
Fig. H
 previous