Filter
Top Products
EdgeStar Mini Kegerator 4
General instructions
Regardless of the brand of 5-liter mini keg, here are the basic steps
for tapping it:
1. Chill your keg- although this mini kegerator has a cooling
plate that will cool your keg, best results will come from a
keg that is already cooled to drinking temperature- this way,
the cooling plate only has to keep your keg cool.
2. Follow the instructions on the mini keg to eliminate excess
gas or pressure.
3. Connect the beer line to the correct dispenser head and tap
the keg (use the included head for Heineken brand
DraughtKeg™ 5 Liter mini kegs; use the optional head for all
other brands)
4. Connect the gas lines (if using the optional head for non-
pressurized 5 Liter mini kegs)
5. Try a test pour to ensure that the beer is flowing freely. If the
test pour is good, then you may begin to enjoy!
Note that you may experience a lot of foam shortly after
tapping the mini keg. If you wait 15-20 minutes after tapping,
the foam should lessen. Additionally, pours with the spout
fully open should deliver less foam than pours with the spout
only partially open.
To put the mini keg into the mini kegerator:
1. Open the mini kegerator door by depressing the button
located on the upper right-hand side of the door.
2. Gently put the mini keg on the cold plate. You may find it
helpful to hook the line(s) up to the mini keg while it is
slightly outside the unit.
To turn the light on and off:
1. If the light is off press the light button to turn on the light.
2. If the light is on press the light button to turn the light off.