Filter
Top Products
1212
1212
12
Step 15Step 15
Step 15Step 15
Step 15
WIRING THE HOODWIRING THE HOOD
WIRING THE HOODWIRING THE HOOD
WIRING THE HOOD
Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 V120 V
120 V120 V
120 V
AC, 15 or 20 Amp cirAC, 15 or 20 Amp cir
AC, 15 or 20 Amp cirAC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
cuit rcuit r
cuit rcuit r
cuit r
equirequir
equirequir
equir
ed.ed.
ed.ed.
ed.
ELECTRICAL GROUNDING INSTRUCTIONSELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONSELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
FailurFailur
FailurFailur
Failur
e to do so can re to do so can r
e to do so can re to do so can r
e to do so can r
esult in death or electricalesult in death or electrical
esult in death or electricalesult in death or electrical
esult in death or electrical
shock.shock.
shock.shock.
shock.
• If not already done, install 1/2” conduit connector
in j-box.
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2” conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover.
Step 16Step 16
Step 16Step 16
Step 16
Final installation stepsFinal installation steps
Final installation stepsFinal installation steps
Final installation steps
Replace filters and install the lamps as described in
the Care & Use section of this manual.
Note:Note:
Note:Note:
Note: Lamps are not supplied, use ONLY 120 Volt,
50 Watt (maximum) 50° halogen light made for a
GU10 base,
suitable for use in open luminariesuitable for use in open luminarie
suitable for use in open luminariesuitable for use in open luminarie
suitable for use in open luminarie.
Turn power on at service panel.
Check operation of the hood.
IMPORTANT: If the hood doesn’t switch ON, before
calling for service, check if the internal General ON/
OFF Pushb-utton Switch is switched ON.
Installing the hood
General ON/OFF
Push button Switch
Back side of the hood
Front side of the hood