Filter
Top Products
99
99
9
Step 4Step 4
Step 4Step 4
Step 4
Remove the junction box cover.
J-Box
Cover
Remove either the top or the back wiring knockout
according the preference and install an approved
wiring clamp
wiring
clamp
Step 5Step 5
Step 5Step 5
Step 5
Remove the duct knockouts using a flat blade
screwdriver and a small hammer.
Use the screwdriver by knocking out the pannel in
similar fashion to a scalpel.
Take care of sharp edges.
Attention!Attention!
Attention!Attention!
Attention!
If it is intended to use the hood in the recirculating
version do not remove any duct knockouts and order
the necessaruy charcoal filter from your supplier.
Rectangular
vertical
discharge
Rectangular
horizontal
discharge
Round
vertical
discharge
R1
R1
R2
R1R1
R1R1
R1= Remove rectangular duct knockout only.
R2R2
R2R2
R2 = Remove semicircular and rectangular duct
knockouts.
Installing the hood