Filter
Top Products
15
Setting Surface Controls
OPERATING THE TRIPLE SURFACE RADIANT ELEMENT
Both the 30” and 36” cooktops are equipped with “Triple” surface radiant elements
located as shown in Figs. 1 & 2. A touch key pad on the element controls is used
to select one of the 3 positions of the element. Symbols and indicator lights on
the control panel are used to indicate which coil of the triple radiant element will
heat. The symbol indicates that only the inner element (See Fig. 3) will heat.
The symbol indicates that both inner and middle elements (See Fig. 4) will heat
together. The
symbol indicates that all 3 portions of the element (See Fig. 5)
will heat. You may switch from either of these settings at any time during cooking.
To Operate the Triple Surface Element:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
POWER
key pad until a beep sound. The power indicator
light above the
POWER
will turn ON. Note: If no other key pad is touched
within 20 seconds the request to Power ON the cooktop will clear.
3. Touch and hold the
On/Off
pad for the desirede triple element position until
a beep is heard. The display will show " -- ".
Note: If no further pads are touched within 10 seconds the request to
power the element ON will clear.
Fig. 1
Fig. 2
NONO
NONO
NO
TETE
TETE
TE
See the Recommended Setting for Surface Elements chart, on page 12, to make the correct setting.