Filter
Top Products
11
Setting Oven Controls
The or pad is used to set the clock. The clock may be set for 12 or 24 hour time of
day operation. The clock is preset at the factory for the 12 hour operation. When the wall
oven is first plugged in or when the power supply to the wall oven has been interrupted, the
display will flash
"PF"
(power failure, See Figure 1).
When
"PF"
appears in the display, press or . A beep will sound and
"PF"
will
disappear.
To set the clock (example below for 1:30):
1. Press or .
"CLO"
and the current time of day will appear in
the display (Figure 2).
2. Press pads to set the time of day to 1:30 (Figure 3).
Press . The time of day will appear in the display (Figure 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold or for 6 seconds (Figure 3).
"CLO"
and the
current time of day will appear in the display (Figure 2). A beep will
sound and
"12h"
(Figure 5) or
"24h"
(Figure 6) will appear in the
display.
2. Press or to switch between the 12 and 24 hour time of day
display. The display will show either
"12h"
(Figure 5) or
"24h"
(Figure
6).
3. Press to accept the change or press or to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
SETTING THE CLOCK
UPPER
ROAST
LOCKED
WARM
BAKE
DELAY
CONV
BROIL
TIMED
UPPER
TIMER
REMOVE
LOWER
DOOR
RACKS
CLEAN
CONV
BROIL
TIMED
WARM
BAKE
DELAY
LOWER
ROAST
LOCKED
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6