Filter
Top Products
16
Fitting the Hob into the worktop
Carry out the building in of the hob as follows:
• put the seals
supplied with the hob, on
the edges of the cut out:
place them exactly on the
front and rear edge and at
50 mm. from the side
edges, as shown in the
diagram, taking care that
the seals meet without
overlapping;
• place the hob in the
cut out, taking care that it is
centred;
• fix the hob with the
relevant fixing clamps and
screws, as shown in the diagram.
When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
FO 0199
Seal
FO 2753