Filter
Top Products
Operating Instructions
11
Setting the water softener
Using the table as a guide, adjust the water softener to that which cor-
responds to the hardness of the water in your area:
0 The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower rack from the
dishwasher.
3. Turn the hardness range switch to 0
or 1 (see table).
4. Replace the lower rack.
Setting electronically:
5. Press the ON/OFF button.
The LED indicators for all programme buttons (and the button for the
delay start timer if present) light up. The LED indicators and any option
buttons that are present only light up if they are activated.
3
If the only LED indicator illuminated is one that belongs to a pro-
gramme button, this means that this dishwashing cycle has been acti-
vated. The dishwashing cycle must be cancelled:
Press function buttons 2 and 3 simultaneously for approx.1 second.
The LED indicators for all programme buttons (and the button for the
delay start timer if present) light up. The LED indicators and any option
buttons that are present only light up if they are activated.
6. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
7. Press function button 1.
The LED indicator for function button 1 will flash. The LED indicator for
the end of the dishwashing cycle is flashing and acoustic signals can be
heard simultaneously (only when the acoustic signal has been acti-
vated):
– The number of times that the LED indicator for the end of the cycle
flashes and the number of acoustic signals correspond to the new
hardness setting.
– This sequence of flashes and acoustic signals is repeated many times,
with a 5 second pause in between.