Filter
Top Products
Operating Instructions
32
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.
...Error messages are displayed.
If your appliance is equipped with an optical floor signal, in the event
of an error a dot-shaped optical signal will flash on the floor.
3
Errors will only be indicated acoustically if the acoustic signal has been
activated.
If, as listed in the table below, any of the indicators in the control panel
or the display panel are flashing or are illuminated, and/or if an acous-
tic signal can be heard, you can probably rectify the fault yourself.
Malfunction Possible cause Remedy
One continuously repeated
warning tone can be heard,
the cycle indicator for the
selected cycle is flashing,
the end cycle indicator is
flashing once repeatedly:
There is no water running
into the dishwasher.
The tap is blocked or
furred with lime-scale
Clean tap
The tap is turned off. Turn the tap on.
The filter (where
present) in the
threaded hose fitting at
the water inlet valve is
blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of
the washing compart-
ment are blocked.
Press the button for the
commenced dishwashing
cycle;
then cancel the dishwashing
cycle (see chapter: Starting a
dishwashing cycle);
Clean out the filters. (See
chapter: Cleaning the filters)
The water inlet hose has
not been correctly laid.
Check hose installation.