Operating instructions
13
3. Fill with rinse aid, up to the broken
line (maximum); this line corresponds
to a quantity of approx. 150 ml
4. Replace the lid and tighten by turn-
ing clockwise.
5. If rinse aid has been spilt, wipe up
with a cloth. Otherwise there will be
foaming during the washing.
Adjusting Rinse Aid Dosing
3
The dose should be adjusted according to the finish and drying results
obtained. The dose is factory set at 4, and can adjusted from 1 to 6.
Gradually increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce if it there are sticky whitish streaks on
the dishes.
0 1. Turn the lid of the container
¼ of a turn anticlockwise and
remove.
2. Adjust the dose setting with a tea
spoon.
3. Replace the lid and tighten by turn-
ing clockwise.
4. If rinse aid has run out, wipe up with
a cloth.
In Daily Use
• Check the salt and rinse aid levels.
• Load cutlery and dishes into the dishwasher
• Fill with dishwasher detergent
• Select a wash programme suitable for the cutlery and dishes
• Start the wash programme
m
a
x
6
5
4
3
2
1