Filter
Top Products
Operating instructions
26
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.
...Error messages
• If the END or DRYING indicator on the programme progress display is
flashing, you can probably rectify the fault yourself.
After rectifying an END or DRYING fault, press the button for the
wash programme that has been started. The wash programme should
continue. If the fault is displayed again, contact AEG Service Force.
• If indicators for other programme steps on the programme progress
display are flashing, please contact AEG Service Force and state the
fault indicated.
Symptom Possible Cause Solution
END on the pro-
gramme progress dis-
play is flashing:
no water is running
into the dishwasher.
Tap is closed. Open tap.
The filter (where present) in
the threaded hose fitting is
blocked.
Clean the filter in the
threaded hose fitting.
The water inlet hose is not
correctly laid.
Check hose installation.
DRYING on the pro-
gramme progress dis-
play is flashing.
The sink outlet is blocked. Clean the sink outlet.
The water drain hose is not
correctly laid.
Check hose installation.
END and DRYING on
the programme
progress display are
flashing simultane-
ously.
The leak prevention system
has been triggered.
Close the tap and contact
AEG Service Force.