Filter
Top Products
Operating instructions
27
...there are problems with the operation of the dish-
washer.
...the wash results are not satisfactory.
The dishes are still dirty.
– The wrong wash programme was selected.
– The dishes were loaded is such a way that the wash waster did not
reach all items. The racks for the dishes must not be overloaded.
– The filter in the base of the washing compartment is dirty or incor-
rectly positioned.
– Detergent was not used or too little was used.
– In the case of scale deposits on the dishes: The special salt container
is empty or the water softener is incorrectly adjusted.
– The drain hose is incorrectly laid.
The dishes are wet and dull.
– Rinse aid was not used.
– The rinse aid container is empty.
Symptom Possible Cause Solution
The programme does
not start.
The door of the dishwasher is
not closed properly.
Shut the door.
Mains plug is not plugged in. Insert mains plug.
House fuse is defective. Replace fuse.
A start delay is selected.
If the dishes are to be
washed immediately, set the
start delay to 0 hours
Rust spots are visible in
the washing compart-
ment.
The washing compartment is
made from rust-free stainless
steel. Rust spots in the wash-
ing compartment are due to
rust particles from external
sources (rust particles from
water pipes, pans, cutlery,
etc.). Remove such spots with
one of the stainless steel
cleaners that are generally
available on the market.
Only wash cutlery and dishes
that are suitable for dish-
washer use.
Close the lid of the special
salt container securely.
There is a whistling
noise during washing.
The whistling is not a cause
for concern.
Use a different brand of
detergent.