Filter
Top Products
23
!
WARNINGWARNING
WARNINGWARNING
WARNING
Disconnect power to the ice maker before making any ice thickness adjustments.
Operation
ICE DISPENSER OPERATION & CARE
The ice cube thickness control is factory set for best overall performance. The
factory setting is designed to
maintain an ice bridge of
approximately 1/16" to 1/8" under
normal conditions resulting in a
dimple of approximately 1/4" to 1/2"
in depth (see Figure 28). A fuller
cube with less of a dimple results in
a thicker ice bridge. As the ice bridge
becomes thicker, the tendency for
the cubes to stay together as a slab
increases. A bridge thicker than 1/8"
may cause cubes to over-fill the ice
bucket.
To adjust:
1 Disconnect power to the unit.
2 Remove the screws securing the
front access panel (see Figure 29).
GOOD
BRIDGE
TOO THIN
BRIDGE
TOO THICK
DIMPLE
TOO DEEP
LITTLE OR
NO DIMPLE
1/4" TO 1/2"
DIMPLE
1/16" TO 1/8"
ICE BRIDGE
BAD
ICE002
Figure 28
Figure 29
ACCESS PANEL SCREWS