Filter
Top Products
12
Operation
BEFORE COOKING
Ensure that the cooktop has been installed by a qualified individual who has tested
the operation of the cooktop in accordance with the Installation Instructions. The
brass burner rings, burner caps, grates, knobs and spill protectors must be in
place for the cooktop to operate properly. All cooktop components must be clean.
Be certain that the gas and electrical power supplies to the cooktop are operational.
Read this Use and Care Manual in its entirety prior to operating the cooktop.
OPERATING THE CONTROL VALVES
To light a particular burner, press down on the corresponding control knob, then
immediately rotate the knob counterclockwise from the “OFF”
position to the “HI/LITE” position. Only the selected burner will
spark continuously until the gas ignites on that burner. The
igniters will stop sparking as soon as the burner ignites.
Once the burner is lit, reduce the flame height if desired by
rotating the control knob further counterclockwise, then place the
utensil on the grate. See Figure 3.
Burner Control Valve
Figure 3