Electrolux E48DF76EPS Range User Manual


 
38
Care and Cleaning
CLEANING KNOBS AND KNOB BEZELS
The control knobs provided with this cooktop are designed for ease of use and
longevity. The “D” shaped design of the knob shaft ensures proper orientation
when reinstalling the knob and knob bezels.
The knobs are made of a composite plastic. These components should be washed
regularly in warm, soapy water. Hand dishwashing liquid is excellent for this task.
Knobs should be removed by gently pulling them straight out and off of the valve
shafts. Use caution to avoid introduction of moisture into the control panel behind
the bezels. To replace knobs, align the “D-shaped” opening at the bottom of the
knob with the “D-shaped” valve shaft, then carefully press the knob onto the valve.
CLEANING BURNER BASES
The burner base is permanently attached to the cooktop. The base should be
wiped clean using a soft cloth or sponge that has been lightly dampened with warm
water and hand dishwashing liquid. Thoroughly clean and dry the igniters to prevent
constant sparking of the reignition system. Refer to the Cleaning the Burner
Igniters section for cleaning tips.
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
Turn the knobs to the “OFF” position prior to removing them from the valve
stems.
The cooktop should never be operated without the knobs in place.
Do not soak the knobs in water or place them in the dishwasher.
Do not expose the knobs to direct flame, hot utensils, or other sources of heat.
Do not use abrasive or corrosive cleaners or applicators, as these could cause
permanent damage.