Filter
Top Products
1
3
Hob installation
. Cut out the worktop according to the cutout size.
The tolerances sizes must not be exceeded. Pre-
cisely saw at the marked line. Recommendation:
Mark the cutout with a steel needle.
. With tile--coated worktop areas any slits in the
surface of the cooking area must be filled up com-
pletely.
. Clean the worktop in the cutout area
. The hob is fitted from the top into the cut--out sec-
tion, centered and firmly pressed on until the
springs will catch.
. Check the sealing in the supporting frame for per-
fect seating and resting without a gap. Please do
not apply additional silicone sealing material.
It will make it harder to dismantle the hob in case
of service.
. 5 holes in the bottom of the build--in case are pro-
vided for the screws of the fitting plates.
. At first screw on the fitting plates with a screw-
driver and afterwards tighten the plates alterna-
tively and diagonally
, until the frame of the cook-
ing area is perfectly laying on the worktop.
. Over--tightening must be avoided! Electric screw-
drivers are to be exclusively used with slip clutch
(setting value 1 -- 1.1 Nm).
1
2
R5
frame
ceramic glass plate
fixing clamp
worktop