Filter
Top Products
SETTING THE TIME
The oven only operates after time set.
When you connect the appliance to the
electrical supply or in case of a power cut,
the Time function indicator flashes automat-
ically.
To set the current time use
or button.
After approximately 5 seconds, the flashing
stops and the display shows the time of
day set.
You can only change the Time of
day
if :
• the switch-on lock is not on
• none of the clock functions Duration
or End is set
• no oven function is set.
Preheat the two ovens. Heat up one oven
at a time.
PRE-HEATING
1.
Set function
and maximum temper-
ature.
2. Let the appliance operate without the
food for approximately 1 hour.
3.
Set function
and maximum temper-
ature.
4. Let the appliance operate without the
food for approximately 10 minutes.
5.
Set function
and maximum temper-
ature.
6. Let the appliance operate without the
food for approximately 10 minutes.
This is to burn off the residue in the appli-
ance. The accessories can become more
hot than usually. When you pre-heat the
appliance for the first time, the appliance
can make an odour and smoke. This is the
usual effect. Make sure the airflow is suffi-
cient.
HOB - DAILY USE
Warning! Refer to "Safety information"
chapter.
CONTROL PANEL LAYOUT
910
1
8 7
2 3 54 6
Use the sensor fields to operate the appliance.
sensor field function
1
with an indicator
locks/unlocks the control panel
2
/
increase or decrease heat setting / time
3
a heat setting display shows the heat setting
6 electrolux