Filter
Top Products
Removing and replacing the wire work
runners
1. Remove all shelves
and furniture from
the oven.
2. Hold the wire work at
the bottom, unclip
from the cavity side
and gently pull to-
wards the centre of
the oven.
3. Unhook the runner
at the top and re-
move from the cavi-
ty.
4. To replace the run-
ners, hook the wire
work side runner into
the cavity, slide back
and press into place.
Warning! Ensure
the wirework runners are firmly in
position before replacing the oven
shelves.
Cleaning the gas hob
Clean the hotplate top using a mild abrasive.
Take care not to damage the spark electro-
des. If the spark electrodes are damaged the
burners will not light.
You can remove the pan supports, burner
caps and burner crowns to clean them.
Again take care not to damage the spark
electrodes.
Clean the burner crowns and pan supports
by soaking them in very hot soapy water.
Aluminium based saucepans can leave shiny
metal marks on the pan supports.
You can remove any stubborn stains by
scouring with a soap impregnated steel wool
pad.
If you look after the burner crowns and pan
supports in this way they will stay reasonably
clean.
However the surface will dull with time. After
cleaning the appliance parts, dry them thor-
oughly before you put them back.
When replacing hob burner parts
1. Crown to body. (Do not try to force the
crown on to the body).
Make sure that the hole in the crown is
over the electrode. Check that the loca-
tion pegs sit in the slots in the body. When
the crown is in this position let it fall freely
on to the body. Check that the crown can
be moved slightly from side to side.
2. Cap to crown. Place cap centrally on the
top of crown (enamel side up). Move side-
ways and front to back to check the cap
is properly fitted.
3. Check for ignition. If a burner will not light
then you need to check the crown and
cap positions.
Important! The 2 piece cap is only available
for tripple crown burners. Not all models
contain the tripple crown burner.
In cases where there are no 2 piece caps you
will receive a single solid cap.
Cleaning the shelves, wire work runners
and grill/oven furniture
All removable parts, except the grill pan han-
dle can be washed in the dishwasher.
The grill pan, grill pan grid, oven shelves and
wire work runners may be cleaned using a
soap impregnated steel wool pad.
Soaking first in hot soapy water will make
cleaning easier.
Cleaning the grill
Do not clean the grill burner itself. Cleaning
the grill may cause the holes in the burner to
become blocked preventing it from operating
correctly.
electrolux 17