Filter
Top Products
It is essential that the appliance is positioned
as Fig 1. a.
Shelves, wall cabinets and cooker hoods
must be fitted a minimum of 750mm directly
above the top of the hotplate (or greater for
cooker hoods if recommended by manufac-
turers instructions) and 400mm above the
hotplate when fitted in line with the outside of
the appliance.
If the units are intended to be fitted adjacent
to the appliance but less than 400mm above
the hotplate, then a minimum space of
50mm must be maintained between the
sides of the unit and the appliance as Fig 1.b.
Curtains must not be fitted immediately be-
hind the appliance or within 150mm of the
sides of the hotplate.
If fitted next to or between two base units a
minimum space of 2mm must be left be-
tween each unit and the sides of the appli-
ance.
The levelling feet fitted to the appliance will
achieve a nominal height to hotplate of
907mm + / - 5mm.
Fig 1.a Fig 1.b
L.P.G. cookers MUST NOT be installed
below ground level i.e. in a basement or
aboard any boat, yacht or other vessel.
Levelling the appliance
Adjustment to suit floor conditions or height
is obtained by rotating clockwise or anti
clockwise the feet at the front and rear of the
appliance.
A spirit level should be placed on one of the
shelves to confirm the appliance is correctly
levelled.
Connecting to the electricity supply
Warning! This appliance must be
earthed. Do not earth this appliance to
the gas supply piping. Connect to 230 -
240V AC supply only.
Connection to the electricity supply should
be made via a properly earthed, readily ac-
cessible wall socket. Which is adjacent to,
but not directly above and not more than
1.7m away from the appliance and capable
of electrical isolation.
The cooker point should be within 1.7m of
the appliance to make it accessible to switch
off the appliance in case of emergency.
The mains lead should be routed so that it
cannot touch hot parts of the cooker i.e. the
back panel above a height of 650mm from
the floor. Should this plug not fit the socket
outlet in your home it should be cut off and
replaced with a suitable plug as outlined be-
low.
If the supply cord is damaged, it must be re-
placed. Please contact your local Service
Force Centre.
If the moulded plug is cut from the cable for
any reason it must be destroyed or disposed
of safely, as protruding wires will be an elec-
trical shock hazard.
If the fitted plug is removed.
The flexible mains lead must be correctly
connected as below to three pin plug of not
less than 13amp capacity.
If a B.S. 1363 fused plug is used, it must be
fitted with a 3 amp fuse which is approved to
B.S. 1362.
Important: The wires in the mains lead
fitted to the appliance are coloured in
accordance with the following code.
• GREEN AND YELLOW = EARTH
•BLUE = NEUTRAL
• BROWN = LIVE
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows:-
The wire which is coloured green and yellow
must be connected to the terminals in the
plug which is marked with the letter E or by
the earth symbol (
) or coloured green or
green and yellow.
22 electrolux